
Selling my portable wide cut band sawmill. It was built by American Bandsaw company in im March of 2020. This unit is fully portable and can go anywhere. It come fully hydraulic except up and down which is electric by push button. It comes with 3 cylinder Yammer Diesel engine that has 38 hp/78ftlbs of torque. It runs great plenty of power and good n fuel. Band wheels and pulleys are are made by Cooks saw manufacturing. Band wheels measure 26'. I also installed cooks felt drip lube system. I love it. Cleans and cools blade at the same time. When I purchased this unit American Bandsaw company did not install an hr meter, so im sorry to say that I dont actually know the exact # of hours. However if you come to look at this unit you can tell by the looks of the mill its not very many. I would guess less 300 hrs. I have almost 20 blades to go with this unit. 6 are sharp. I will try to drop off the blades so they can be sharpened. I can deliver inside of a 100 miles if need be. This mill comes with a toe board for leveling logs, log loader, and log turner. discharge side blade guide is hydraulic in and out. Log clamps are hydraulic in and out. This mill will cut 50' wide by 20' 6'' long. Recently installed a cooks spring tension system for added consistency during milling and added blade life. All the filters and belts have been replaced. All available maintenance has been done. This mill is ready to go.

Selling my portable wide cut band sawmill. It was built by American Bandsaw company in im March of 2020. This unit is fully portable and can go anywhere. It come fully hydraulic except up and down which is electric by push button. It comes with 3 cylinder Yammer Diesel engine that has 38 hp/78ftlbs of torque. It runs great plenty of power and good n fuel. Band wheels and pulleys are are made by Cooks saw manufacturing. Band wheels measure 26'. I also installed cooks felt drip lube system. I love it. Cleans and cools blade at the same time. When I purchased this unit American Bandsaw company did not install an hr meter, so im sorry to say that I dont actually know the exact # of hours. However if you come to look at this unit you can tell by the looks of the mill its not very many. I would guess less 300 hrs. I have almost 20 blades to go with this unit. 6 are sharp. I will try to drop off the blades so they can be sharpened. I can deliver inside of a 100 miles if need be. This mill comes with a toe board for leveling logs, log loader, and log turner. discharge side blade guide is hydraulic in and out. Log clamps are hydraulic in and out. This mill will cut 50' wide by 20' 6'' long. Recently installed a cooks spring tension system for added consistency during milling and added blade life. All the filters and belts have been replaced. All available maintenance has been done. This mill is ready to go.